Does anyone have experience with Belzona 1111 nozzle sleeves in place of internal liquid coating repairs on water treatment tank nozzles, specifically effluent water with MEG/Oil contamination?
* Are these a suitable alternative to liquid coating repairs?
* Did the use of these sleeves save time and resources when compared to the application of liquid coatings?
* What was the performance of these sleeves, did they exhibit any premature failures?
* Any other technical advice with regards to the use of these sleeves.Please provide your feedback on the above.Thanks & Regards,Gyananjan Mahanty
I would recommend FRP or Dual-lam prefabricated Nozzle-sleeves that you can insert into your damaged nozzles. To get a good contact to the existing nozzle you need to clean grit blast and then apply Belzona or do an injection with EPOXIGARD HC from Koch Knight which will giver a tighter and controllable connection between parts.
Dipl. Ing. Matthias Walschburger
Business Director, Global Projects
Tel: +1 234 901 1772
Cell: +1 330 280 2489
This communication is for use by the intended recipient and contains information that may be privileged, confidential or copyrighted under applicable law. If you are not the intended recipient, you are hereby formally notified that any use, copying or distribution of this e-mail,in whole or in part, is strictly prohibited. Please notify the sender by return e-mail and delete this e-mail from your system. Unless explicitly and conspicuously designated as "E-Contract Intended", this e-mail does not constitute a contract offer, a contract amendment, or an acceptance of a contract offer. This e-mail does not constitute a consent to the use of sender's contact information for direct marketing purposes or for transfers of data to third parties.